Advertisement
0
When you charge a new battery cartridge or a battery cartridge which has not been used
for a long period,
it
may not accept
a
full charge. This is
a normal
condition and does
not indicate a problem. You can recharge the battery cartridge fully after discharging
it
almost completely a couple of times.
0
If you wish to charge two battery cartridges, allow 15 minutes between chargings on the
fast charger.
Installing or removing drill
bit
or driver
bit
CAUTION :
Always be sure that the tool is switched off and the battery cartridge is removed before
installing o r removing the bit.
To install the bit, place
it
in the chuck as
far as it will go. Tighten t h e chuck by hand.
Place the chuck key in each of the three
holes and tighten clockwise. Be sure to
tighten all three chuck holes evenly.
To remove t h e bit, turn the chuck key
counterclockwise in just one hole, then
loosen t h e chuck by hand.
After use, return the chuck key to the
storage cavity on the
tool.
Holding tool
H'old the tool as shown in the figure.
When drilling a large diameter hole, hold
the tool firmly with both hands.
fi
Tighty
/
Chuck key
7
Advertisement
