Advertisement
TProttle wire
io throttle
lever
STEP
1
Flcj 9
Throttle wre ano
Mounting the handle and connecting the throttle
wire
a n d switch cords.
1
klatch the protrusions on the handle joint
10
the slot
in
the underside
of
the handle and tighten h e four
2
Connect the throttle wires and firmly close the cable joint (as shown in 3 steps in Fig
7 )
3 Connect the switch cords
to
the two cords from the engine by inserting one
into
the other
4
Wrap the waist pad around the drive shaft so tnat the hanger will protrude through the
slit in
the waist
pad
and
the throttle wire and
cords w1' I
also
be
wrapped under the waist pad (Fig
8 )
5 Secure the throttle wire with the w e clip as shown
in the
figure for easy oDeratioi1 (Fig 9)
6
Cover the throttle wire and swtct? cords
w t h
split tubing (Fig 10)
motor cover to rernove sixk fiom the wires
socket head bolts M 5 evenly to secure the handle (Fig 5,6)
Note Squeeze the throttle lever to make sure that the throttle wire moves smoothly
Notes
It
IS
easier
to instdl
ihe
split tcrbing
if
the bullet connectors are partially pished into the
6
Advertisement
