Configure Your Pap2 For Outbound Calling - Linksys PAP2 Configuration Manual

CONFIGURE YOUR PAP2 FOR OUTBOUND CALLING

To connect to the PAP2 Web interface:
1. Pick up the handset of the phone connected to the PAP2, and then, using the phone's keypad, press
the star key (*) four times: ****.
2. When you hear an Interactive Voice Response (IVR) prompt, press 110#. When the system
announces the PAP2's IP address, write it down.
To configure the PAP2 to make outbound calls:
1. Using a PC on the same network as the PAP2, launch a Web browser, and in the Address bar, enter
the PAP2's IP address (obtained in the previous section).
2. Click the Admin Login link, located in the upper right-hand corner of the page.
3. Click the switch to advanced view link.
4. Click the tab for Line1 or Line2 at the top of the page, depending on which line you are configuring.
5. In the NAT Settings section, change the value of the following field:
NAT Keep Alive Enable—no
6. In the Proxy and Registration section, change the value of the following fields:
Proxy— sip.landose.com
Use Outbound Proxy— no
Use OB Proxy In Dialog— no
Make Call Without Reg— yes
Ans Call Without Reg— yes
DNS SRV Auto Prefix— no
7. In the Subscriber Information, enter No_Number in the Display Name field.
8. Enter the User ID (account number) and Password (passcode).
9. Change the value of the Use Auth ID field to no.
Landose Configuration Guide for the Linksys PAP2
Line 1 and Line 2 must have a different account number and passcode.
Note:
Page 2