Sanding Operation - Makita BO6040 Instruction Manual

1
003329
OPERATION

Sanding operation

003338
CAUTION:
Never switch on the tool when it is in contact with
•
the workpiece, it may cause an injury to operator.
Never run the tool without the abrasive disc. You
•
may seriously damage the pad.
Never force the tool. Excessive pressure may
•
decrease the sanding efficiency, damage the
abrasive disc or shorten tool life.
Hold the tool firmly. Turn the tool on and wait until it
attains full speed. Then gently place the tool on the
workpiece surface. Keep the pad flush with the
workpiece and apply slight pressure on the tool.
Polishing operation
CAUTION:
Use only a Makita genuine sponge pad, felt pad or
•
wool pad (optional accessories).
Always operate the tool at low speed to prevent
•
work surfaces from damage/burning.
Never force the tool. Excessive pressure may
•
decrease the polishing efficiency and cause motor
overload, resulting in tool malfunction.
1. Joint
7
1. Applying wax
1
003340
Use an optional sponge pad. Apply wax to the
sponge pad or work surface. Run the tool at low
speed to smooth out wax.
NOTE:
First, wax a not conspicuous portion of the work
•
surface to make sure that the tool will not scratch
the surface or result in uneven waxing.
2. Removing wax
1
003342
Use an optional felt pad. Run the tool at low speed
to remove wax.
3. Polishing
1
003344
Use an optional wool pad. Run the tool at low
speed and apply the wool pad gently to the work
surface.
1. Sponge pad
1. Felt pad
1. Wool pad