Makita BO6040 Instruction Manual page 6

CAUTION:
Do not rotate the change lever when the tool is
•
running. The tool will be damaged.
Typical applications for sanding and polishing
Sanding
Use/Material Mode selection
Paintwork:
Sanding Random
Repairs Roto-orbit/
(scratches, rust spoots) Random
Rough paint stripping Roto-orbit
Plastics:
Soft plastics Roto-orbit/
(PVC/ABS) Random
Hard plastics Roto-orbit
(FRP)
Woods:
Softwood Random
Hardwood Roto-orbit/
Random
Veneers Random
Metals:
Non-ferrous metal Roto-orbit/
(aluminum, copper) Random
Steel Roto-orbit
Steel,rust removal Roto-orbit
Hard metal Roto-orbit
(stainless steel)
Polishing
Mode selection Speed control
Use/Material
Applying wax Roto-orbit
Removing wax Roto-orbit
Polishing Roto-orbit
003294
The above information is intended only as a guide. In
each case, the most appropriate sanding disc grain
should be determined by preliminary trials.
ASSEMBLY
CAUTION:
Always be sure that the tool is switched off and
•
unplugged before carrying out any work on the tool.
Installing side grip (optional accessory)
1
003297
Remove one of the screws which secure the head cover.
Screw the side grip on the tool securely. The side grip
can be installed on either side of the tool.
Speed control
Pad
setting
1 - 3 Soft
2 - 3 Hard
4 - 5 Soft
1 - 3 Super soft/
Soft
1 - 3 Soft/Hard
1 - 3 Super soft/
Soft
3 - 5 Soft
1 - 2 Super Soft
1 - 3 Soft
3 - 5 Soft/Hard
4 - 5 Super Soft
4 - 5 Soft
Pad
setting
2 - 4 Sponge pad
4 - 5 Felt pad
4 - 5 Wool pad
1. Side grip
Installing or removing abrasive disc
003302
CAUTION:
Always use hook-and-loop system abrasive discs.
•
Never use pressure-sensitive abrasive discs.
To install the abrasive disc, first remove all dirt or foreign
matter from the pad. Then attach the abrasive disc to the
pad, using the hook-and-loop system of the abrasive disc
and the pad. Be careful to align the holes in the abrasive
disc with those in the pad.
To remove the disc from the pad, just pull up from its
edge.
Changing pad
1
3
003315
Makita offers an extensive range of optional super soft,
soft and hard pads. Remove the screw counterclockwise
from the center of the base with a hex wrench. After
changing the pad, tighten the screw clockwise securely.
Dust collection (optional accessory)
1 2
003328
If a Makita hose is used, you can connect the cuff to the
dust outlet directly.
If other hose with an inner diameter of 24 mm, attach the
joint between the dust outlet and the cuff.
6
1. Abrasive disc
1
2 1. Screw
2. Hex wrench
3. Pad
3
1. Dust outlet
2. Cuff
3. Hose