Functional Description - Makita HM0810 Instruction Manual

FUNCTIONAL
DESCRIPTION
1
2
1. Lock button
2. Switch trigger
ASSEMBLY
1. Side grip
1. Bull point
2. Tool retainer
CAUTION:
• Always be sure that the tool is switched off and unplugged before
adjusting or checking function on the tool.
Switch action
002887
CAUTION:
• Before plugging in the tool, always check to see that the switch trigger
actuates properly and returns to the "OFF" position when released.
To start the tool, simply pull the switch trigger. Release the switch trigger to
stop.
For continuous operation, pull the switch trigger and then push in the lock but-
ton.
To stop the tool from the locked position, pull the switch trigger fully, then
release it.
CAUTION:
• Always be sure that the tool is switched off and unplugged before
carrying out any work on the tool.
Installing side grip (auxiliary handle)
002900
The side grip swings around to either side, allowing easy handling of the tool in
any position. Loosen the side grip by turning it counterclockwise, swing it to the
1
desired position and then tighten it by turning clockwise.
Installing or removing the bit
004870
For HM0810
1
Pivot the tool retainer to the side.(If it is difficult to move the tool retainer with
your thumbs, tap it with a hammer.) Insert the bit into the tool barrel as far as it
2
will go. Return the tool retainer to its original position to secure the bit.
To remove the bit, follow the installation procedure in reverse.
5