Makita HM0810T Instruction Manual
Demolition hammer
Hide thumbs
Also See for HM0810T:
- Instruction manual (37 pages) ,
- Instructions manual (8 pages) ,
- Technical information (2 pages)
Related Manuals for Makita HM0810T
Summary of Contents for Makita HM0810T
- Page 1 INSTRUCTION MANUAL Demolition Hammer HM0810T 010079 DOUBLE INSULATION IMPORTANT: Read Before Using.
-
Page 2: Specifications
European Standard EC Declaration of Conformity and can, therefore, also be used from sockets without Makita Corporation responsible earth wire. manufacturer declare that the following Makita ENG905-1 Noise machine(s): The typical A-weighted noise level determined according Designation of Machine: to EN60745: Demolition Hammer Model No./ Type: HM0810T... - Page 3 Europe who is: Keep cord away from heat, oil, sharp edges or Makita International Europe Ltd. moving parts. Damaged or entangled cords Michigan Drive, Tongwell, increase the risk of electric shock.
- Page 4 power tool will do the job better and safer at the Wear a hard hat (safety helmet), safety glasses rate for which it was designed. and/or face shield. Ordinary eye or sun 19. Do not use the power tool if the switch does glasses are NOT safety glasses.
-
Page 5: Functional Description
Installing or removing the bit FUNCTIONAL DESCRIPTION 1. Bit CAUTION: 2. Change ring Always be sure that the tool is switched off and • unplugged before adjusting or checking function on the tool. Switch action 1. Lock button 2. Switch trigger 010080 1. -
Page 6: Replacing Carbon Brushes
Run the tool for several minutes to warm it up. Switch off and unplug the tool. Remove the crank cap using a Makita lock nut wrench 35 (optional accessory). Rest the tool on the table with the bit end pointing upwards. This will allow the old grease to collect inside the crank housing. - Page 7 Bushing tool • Ground rod adapter • Lock nut wrench • Hex wrench • Safety goggles • Hammer grease • Carrying case •...
- Page 8 Makita Corporation Anjo, Aichi, Japan www.makita.com 884096D223...