Care And Maintenance; Sr1530 Specifications - Mackie SR1530 User Manual

CARE AND
MAINTENANCE
Your Mackie loudspeakers will provide
many years of reliable service if you follow
these guidelines:
Avoid exposing the
loudspeakers to mois-
ture. If they are set up
outdoors, be sure they
are under cover if you
expect rain.
• Avoid exposure to extreme cold (below
freezing temperatures). If you must
operate the loudspeakers in a cold
environment, warm up the voice coils
slowly by sending a low-level signal
through them for about 15 minutes
prior to high-power operation.
• Use a slighty damp cloth with a mild
soap solution to clean the cabinets. Only
do this when the power is turned off.
Avoid getting moisture into any of the
openings of the cabinet, particularly
where the drivers are located.

SR1530 SPECIFICATIONS

System Specifications
Frequency Range (–10 dB)
40Hz–20kHz
Frequency Response (–3 dB)
45Hz–18kHz
Horizonal Coverage Angle (–6 dB)
90º averaged 2kHz to
10kHz
Vertical Coverage Angle (–6 dB)
40º averaged 2kHz to
10kHz
Directivity Factor; DI (Q)
10.77 (11.95) averaged
2kHz to 10kHz
Maximum SPL @ 1m 123 dB
Peak Output @ 1m 126 dB
Crossover Points 700Hz, 3000Hz
Dynamic Range > 100 dB
± 40º from 500Hz to
Phase Response
10kHz
Input Type Balanced differential
Input Impedance 50K ohms
Input Protection Monitoring and
limiting of continuous
rms output of amplifiers
Thermal Protection Input stage muting,
auto-reset
Transducer Specifications
Low-Frequency Transducer
Diameter 15˝ (381mm)
Voice Coil Diameter 2.5˝ (63mm)
Power Handling 250W rms (long term)
8
Mid-Frequency Transducer
Diameter
Voice Coil Diameter
Power Handling
High-Frequency Transducer
Diaphragm Diameter
Voice Coil Diameter
Power Handling
Diaphragm Material
Power Amplifiers
Low-Frequency Power Amplifier
Rated Power
Rated THD
Design
Mid and High-Frequency Power Amplifiers
Rated Power
Rated THD
Design
Line Input Power
US
Recommended Amperage Service:
Europe
Recommended Amperage Service:
Physical Properties
Height
Front Width
Rear Width
Depth
Weight
Enclosure
Mounting Methods
1 Power handling for transducers is based on an AES long term power
ing standard conducted for 100 hours full power, free air.
Disclaimer
Since we are always striving to make our
products better by incorporating new and improved
materials, components, and manufacturing methods,
we reserve the right to change these specifications at
any time without notice.
"Mackie" and the "Running Man" figure are
trademarks or registered trademarks of Mackie
Designs Inc.
All other brand names mentioned are trade-
marks or registered trademarks of their respective
holders, and are hereby acknowledged.
©2002 Mackie Designs Inc.
1
All Rights Reserved.
Rev. D 03/02
6˝ (152mm)
2˝ (50mm)
60W rms (long term) 1
1˝ (25mm)
1˝ (25mm)
25W rms (long term)
1
Mylar
300 watts RMS
< 0.05%
Class G, High
Efficiency/High Current
100 watts RMS
< 0.1%
Integrated Module
120V, 60Hz
8 amps
230V, 50Hz
5 amps
43.9˝ (1116mm)
19.1˝ (484mm)
13.9˝ (352mm)
18.1˝ (460mm)
111.25 lbs. (50.57 kg)
Trapezoidal, 10º sides,
18mm multi-layered
plywood, top and bottom
high pressure resin
injected "caps"
Floor mount only.
The SR1530 should
never be pole-mounted.
The cabinet has no rig-
ging points and is not
suitable for flying.
Never attempt to sus-
pend the cabinet by
its handles.
test-