Fujitsu M10 Installation Manual page 182

labels.
Figure 5-7 Link cable (optical) shape
a. Connect one end of a link cable to the port (B in
b. Connect the other end to the port (B in
c. Connect one end of the other link cable to the port (C in
d. Connect the other end to the port (C in
Note - The two ports have the same shape and so may be incorrectly connected. Check the
labels at both ends of each cable to confirm that the cable is connected to the correct ports.
Hold the connector of the link cable (electrical) or link cable (optical), and insert it straight
into the opening. Do not hold the cable when inserting it.
Note - PCI cassettes are mounted upside down in the SPARC M10-4/M10-4S and the PCI
expansion unit. Accordingly, the port locations of PCI cards, including the link card, are also
upside down. Be careful about this when mounting the cables.
Fujitsu M10/SPARC M10 Systems Installation Guide ･ July 2015
168
of the PCI expansion unit.
link card of the SPARC M10 chassis.
board of the PCI expansion unit.
link card of the SPARC M10 chassis.
Figure 5-8) on the link board
Figure 5-9 or B in Figure
Figure
Figure 5-9 or C in Figure
5-10) on the
5-8) on the link
5-10) on the