Functional Description - Makita BO4565 Instruction Manual

FUNCTIONAL DESCRIPTION

CAUTION:
Always be sure that the tool is switched off and
•
unplugged before adjusting or checking function
on the tool.
Switch action
1
008302
CAUTION:
Before plugging in the tool, always check to see
•
that the tool is switched off.
To start the tool, press the " I " side of the switch. To
stop the tool, press the " O " side of the switch.
ASSEMBLY
CAUTION:
Always be sure that the tool is switched off and
•
unplugged before carrying out any work on the
tool.
Installing or removing abrasive paper
NOTE:
Use Makita hook-and-loop sandpaper with this sander.
To attach the sandpaper:
2
008304
1. Switch
1. Velcro
1
sandpaper
2. Base
1
008305
1
2
008306
1. Set the tool upside down so that the pad is on top.
2. Position the sandpaper to fit the shape of the
base. Be sure to align the holes on the sandpaper
with the holes on the pad (the dust will be sucked
into these holes; it is therefore important to leave
them open).
3. Press the paper firmly over the pad.
To remove the sandpaper:
1. Set the tool upside down so that the sandpaper is
on top.
2. Grasping one corner of the sandpaper, peel it
from the pad.
NOTE:
If the sandpaper is in good condition, save it for
•
further use.
When sanding in narrow, hard-to-reach areas (e.g.,
shutters, blinds, louvers), attach the cone-shaped
abrasive papers to the end of the pad (bottom and top).
To sand the end of thin materials, fold the abrasive
paper and attach to the side of the pad as shown in the
figures.
Dust bag (accessory)
008301
The use of the dust bag makes sanding operations
clean and dust collection easy. To attach the dust bag,
5
1. Velcro
sandpaper
2. Base
2
1
1. Base
2. Velcro
sandpaper
1. Dust bag
1