Wireless-G Broadband Router with 2 Phone Ports
The Front Panel
The Router's LEDs, where information about network activity is displayed, are located on the front panel.
Figure 3-2: The Broadband Router's Front Panel
Power
Green. The Power LED lights up when the Router is powered on. The LED flashes while the
Router is booting up, running a system self-test, or upgrading its firmware.
WLAN
Green. The WLAN LED lights up whenever there is a successful wireless connection. If the LED
is flashing, the Router is actively sending or receiving data over the wireless network.
Ethernet 1-3
Green. The Ethernet LED serves two purposes. If the LED is solidly lit, the Router is connected
to a device through the corresponding port (Ethernet 1, 2, or 3). If the LED is flashing, the
Router is sending or receiving data over that port.
Phone 1-2
Green. The Phone LED serves two purposes. The LED is solidly lit when there is a registered
connection to babyTEL through the corresponding port (Phone1 or Phone2).
It is not lit when there is no registered connection. The LED flashes when the phone is being
used or an incoming call has been detected.
Internet
Green. The Internet LED lights up when the Router is connected to your cable or DSL modem.
If the LED is flashing, the Router is sending or receiving data over the Internet port.
Proceed to "Chapter 4: Connecting the Router."
Chapter 3: Getting to Know the Wireless-G Broadband Router with 2 Phone Ports
The Front Panel
7