Linksys EtherFast BEFSR11, BEFSR41 User Manual page 14

Cable/dsl router instant broadband series

Hide thumbs Also See for EtherFast BEFSR11, BEFSR41:

Table of Contents

EtherFast Cable/DSL Routers

4. Connect the power-supply cable to the Power port on the rear of the

Router, then plug the supplied AC power cable into a power outlet. Plug the

other end into the back of the power adapter.

• The Power LED will illuminate green as soon as the power adapter is

connected.

• The Diag LED will illuminate red for a few seconds while the Router

goes through its internal diagnostic test. The LED will turn off when the

self-test is complete.

5. Power on the Cable or DSL modem.

6. Press the Reset button on the front of the router. Hold the button in for

three seconds, or until the Diag LED illuminates red. This restores the

router's default settings.

The Hardware Installation is complete. Continue to the next page to con-

figure the router's settings.

Table of Contents