Show Interfaces Status - Dell S4810 Reference Manual

pkts
Output Statistics:
pkts
Rate info (interval 299 seconds):
Time since last interface status change: 3w0d17h
GigabitEthernet 0/2 is down, line protocol is down
Hardware is Force10Eth, address is 00:01:e8:4c:f2:83
!-------------output truncated ----------------!
Related
show hardware stack-unit
Commands
output statistics.
show interfaces
interface.

show interfaces status

S4810
Syntax
show interfaces [interface | linecard slot-number] status
Parameters
interface
linecard slot-
number
Defaults none
Command
•
Modes
780
0 over 255-byte pkts, 0 over 511-byte pkts, 0 over 1023-byte
0 Multicasts, 0 Broadcasts
0 runts, 0 giants, 0 throttles
0 CRC, 0 overrun, 0 discarded
0 packets, 0 bytes, 0 underruns
0 64-byte pkts, 0 over 64-byte pkts, 0 over 127-byte pkts
0 over 255-byte pkts, 0 over 511-byte pkts, 0 over 1023-byte
0 Multicasts, 0 Broadcasts, 0 Unicasts
0 throttles, 0 discarded, 0 collisions
Input 00.00 Mbits/sec, 0 packets/sec, 0.00% of line-rate
Output 00.00 Mbits/sec, 0 packets/sec, 0.00% of line-rate
Current address is 00:01:e8:4c:f2:83
— displays information on a specific physical interface or virtual
(OPTIONAL) Enter one of the following keywords and slot/
port or number information:
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
• For a Loopback interface, enter the keyword loopback
then the slot/port information. The range is from 0 to
16383.
• For a Port-Channel interface, enter the keyword port-
channel then the slot/port information. The range is
from 0 to 128.
(OPTIONAL) Enter the keyword linecard then the slot
number.
EXEC
— displays data plane and management plane input/
Interfaces