Dell S4810 Reference Manual page 1144

CPU
interface
interface
Defaults none
Command
•
Modes
•
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.1
Example
Dell#
IPv6 Address
Hardware Address
---------------------------------------------------------------
--------------------------------------------------------
100::1
0.03
-
fe80::200:ff:fe00:22
00:00:00:00:00:22
500::1
0.60
fe80::200:ff:fe00:17
00:00:00:00:00:29
900::1
0.60
400::1
0.60
1144
Enter the keyword cpu then either rp1 or rp2 (Route
Processor 1 or 2), optionally then an IPv6 address to display
the IPv6 neighbor entries stored on the designated RP.
Enter the keyword interface then the interface type and
slot/port or number information:
• For a Fast Ethernet interface, enter the keyword
fastEthernet then the slot/port information.
• For a Port Channel interface, enter the keywords port-
channel then a number.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
• For a VLAN, enter the keyword vlan then the VLAN ID.
The range is from 1 to 4094.
EXEC
EXEC Privilege
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
show ipv6 neighbors
State
00:00:00:00:00:22
CP
00:01:e8:17:5c:af
00:01:e8:17:5c:b1
00:01:e8:17:5c:ae
Interface
DELAY
STALE Te 0/12
REACH
REACH Te 0/14
STALE
REACH
Expires(min)
VLAN CPU
Te 0/12
232
- CP
Te 0/13 -
232
- CP
Po 23 -
te 0/2 Vl
Neighbor Discovery Protocol (NDP)
CP
CP
100