Bottom Panel; Power; Connecting Power To The Chargebase - Honeywell Dolphin 70e Black User Manual

Bottom Panel

For details on how to mount the base, see
Serial Number Label

Power

The terminal requires 12 Volts DC input for battery charging and power output to the terminal. The power
adapter included with the base, converts the voltage from the AC power source to 12 volts DC. Use only
a UL Listed power supply, which has been qualified by Honeywell with output rated at 12VDC and
5 amps with the device. The operating temperature range is -10° to 50°C (14° to 122°F).
Honeywell recommends that you leave the ChargeBase connected to its power source at all times, so
that it is always ready to use.
We recommend use of Honeywell peripherals, power cables, and power adapters. Use of any non-Honeywell
peripherals, cables, or power adapters may cause damage not covered by the warranty.

Connecting Power to the ChargeBase

A/C Power Cord
1. Plug the A/C power cord into the power adapter.
2. Plug the power cable into the power connector on the back of the ChargeBase.
3. Plug the A/C power cord into a grounded power source.
4. The base is ready to begin charging terminals.
12 - 4
Mounting the ChargeBase
Compliance Label
Power LED
on page
Power Adapter
12-5.
Power Connector Cable