Vacuum Operation - Black & Decker LSWV36 Instruction Manual

• Hold the sweeper with one hand as shown in
figure k and sweep from side to side with the
nozzle several inches above the hard surface.
Slowly advance keeping the accumulated pile
of debris in front of you.

vacuum operation

note: Ensure the sweeper is switched off and the battery is removed
from tool before attaching or removing the vacuum tubes. The vacuum
tube and collection bag must be assembled to the housing before use.
Install battery after assembly just prior to use.
• Attach the collection bag to the power head as shown in figure E.
• Remove the fan cover from the side of the sweeper housing by
pressing the spring loaded release button (located on the lower right
side of the sweeper housing) and pulling the cover off (figure g).
• Attach the vacuum tube assembly
to the fan inlet on the sweeper
housing (figure H) by lining up the
tabs on the tube with the slots on
the sweeper housing and push
inwards until the locking/release
button is fully engaged. (figure H1)
• Position the tube slightly above
the debris/leaves. Turn the unit on,
then using a side to side sweeping
motion the debris/leaves will be
sucked up the tube, mulched and
deposited into the collection bag
(figure L) .
k
L
As the bag fills the power of the suction will decrease. To empty
collection bag, switch off your product and remove the battery from
the tool. Remove the collection bag from the power head, unzip the
collection bag to empty. Re-assemble before continuing to operate.
When used properly on the correct applications, this unit should not jam. This
tool is not intended to vacuum wet leaves or debris and is designed primarily
for clean up of hard surfaces like decks, patios or garages. The tool should not
be used to vacuum litter or non-organic debris.
WHAT TO DO If THE UNIT jAMS: (FigURE M)
CAUtiOn: tURn OFF Unit AnD REMOVE BAttERY FROM tOOL.
If the unit motor stops, the fan has become jammed. If this
happens,turn the unit off then remove the battery. Remove the bag
and vacuum tube. Remove the jamming material using a small
wooden stick. Do not use a metal implement or anything, which
may damage the fan or scratch the plastic. Ensure the fan will turn
by hand before reassembling the unit.
If the unit stops picking up debris or the performance substantially
reduces it may have become clogged. Switch the unit off then
remove the battery. Remove the vacuum tube and look down the
tube to ensure no debris is blocking it. If necessary remove debris
with a small wooden stick. Do not use a metal implement or
anything, which may scratch or
damage the tube. Remove the bag.
If the bag is full, empty the bag. If
necessary remove any debris
from around the fan or unit outlet
using a small wooden stick.
Do not use a metal implement or
anything which may damage the
fan or scratch the plastic. Ensure the
fan will turn by hand before
reassembling the unit
10
M