Bios Setup Utility; Using The Bios Setup Utility - NEC I-Select TW100 User Manual

I-Select TS100 / I-Select TW100 User Guide - Configuring Your System

BIOS Setup Utility

The BIOS Setup Utility is used to change system configuration parameters. The utility
is resident in the system FLASH memory and does not require a diskette or an operat-
ing system present to run.

Using the BIOS Setup Utility

You access the BIOS Setup utility when you turn on or reboot your system. To run the
BIOS Setup Utility, perform the following procedure:
1. Power-on or reboot the system. "Press <DEL> to enter SETUP" displays.
2. Press DEL. The BIOS Setup Utility starts and the Main Menu is displayed. The
Main Menu lists the following selections:
Display
Standard CMOS Features
Advanced
Integrated Peripherals
Power Management Setup
PnP/PCI Configurations
PC Health Status
MB Intelligent Tweaker (M.I.T.) Use this menu to change CPU's clock and voltage
Load Optimized Defaults
Set Supervisor Password
Set User Password
Save & Exit Setup
Exit Without Saving
Use the arrow keys to select a menu or an item on a displayed menu. Press the value
keys (listed in the table below) to cycle through the allowable values for the selected
field. Use the "Save & Exit Setup" item to save the current values on all the menus.
To display a submenu, position the cursor on a selection that has a submenu and press
ENTER. An arrow precedes selections with submenus.
Refer to the following table for information on the keys that you use with BIOS Setup.
These keys are also listed at the bottom of the Setup menu.
Key
F1
ESC
Left or right arrow keys
Up or down arrow keys
Table 3 - 1: Main Menu
Use
Use this menu for basic system configuration.
Use this menu for setting the Advanced Features available on your system.
Use this menu for setting onboard IO, IRQ, DMA assignment.
Use this menu for setting your system's power management.
Use this menu to configure server specific options.
Use this menu to display server information.
Press Enter to load factory default values.
Press Enter to set a supervisor password.
Press Enter to set a user password.
Press Enter to save and exit the BIOS Setup utility
Press Enter to exit without saving changes.
Table 3 - 2: BIOS Setup Keys
Function in Setup Menu
Get Help about an item.
Exit the current menu and return to the previous menu.
Move between menus.
Move cursor up and down. The cursor moves only to the settings
that you can change.
3 - 3