System Initialization; Entering The Security Code - Honda 2006 Civic Sedan Owner's Manual

System Initialization

System Initialization
If for any reason, you lose power to the
navigation system (like the battery was
disconnected), the navigation system
will require initialization. Once
completed, your system will be ready
to use.
This initialization requires the
following:
• Entry of the 4-digit anti-theft
security code to ''unlock'' the
system.
• GPS initialization (may not be
needed depending on the length of
time the system was without power).
• Map matching to align the GPS
coordinates to a place on the map.
90 Navigation System

Entering the Security Code

If the battery goes dead or is
disconnected for any reason, you will
have to enter a security code for the
navigation system before you can use it
again.
When you purchased the vehicle, you
should have received a card that has the
system's security code and serial
number. Keep this card in a safe place
in case you need the code. If you lose
the card, you must obtain the security
code from your dealer.
Enter the four-digit security code, then
select Done. If you have entered it
correctly, the display changes to the
Disclaimer screen. If you make a
mistake, the system will display
"Incorrect PIN". Re-enter the 4-digit
security code. You have ten chances to
enter the correct code. If all ten are
incorrect, turn the ignition to OFF, then
back to ON (II) to have ten more
chances to enter the correct code.
NOTE: The anti-theft security code is
unrelated to your optional Navigation
system PIN (for Personal or Home
Address).