Command Line Interface; To Connect A Switch Via Telnet; Logging On To The Command Line Interface; Cli Commands - D-Link DGS-1210-28 Reference Manual

Web smart switch
Hide thumbs Also See for DGS-1210-28:
Table of Contents

Advertisement

5 Command Line Interface

5
Command Line Interface
The D-Link Web Smart Switch allows a computer or terminal to perform some basic monitoring and
configuration tasks by using the Command Line Interface (CLI) via TELNET protocol.

To connect a switch via TELNET:

1. Make sure the network connection between the switch and PC is active.
2. To connect, launch any terminal software like HyperTerminal in Microsoft Windows, or just use the
command prompt by typing the command telnet followed by the switch IP address, eg. telnet 10.90.90.90.
3. The logon prompt will appear.

Logging on to the Command Line Interface:

Enter your User Name and Password to log in. The default user name and password is admin. Note that the
user name and password are case-sensitive. Press Enter in both the Username and Password fields. The
command prompt will appear as shown below (DGS-1210-28>):
DGS-1210-28 login: admin
Password:
DGS-1210-28>
The user session is automatically terminated if idle for the login timeout period. The default login timeout
period is 5 minutes. To change the login timeout session, please refer to chapter 5.

CLI Commands:

The Basic Switch commands in the Command Line Interface (CLI) are listed (along with the appropriate
parameters) in the following table.
Command
?
download
Upload
config ipif system
config ipif system
logout
ping
ping6
create iproute
delete iproute
show iproute
reboot
reset config
show ipif
Figure 5.1 – Command Prompt
Parameter
{ firmware_fromTFTP | cfg_fromTFTP } {<ipaddr> | <ipv6addr>}
<path_filename>
{ firmware_fromTFTP | cfg_fromTFTP } {<ipaddr> | <ipv6addr>}
<path_filename>
{ ipaddress <ip-address> <subnet-mask> gateway <gw-address> | dhcp |
bootp }
{ ipv6 ipv6address <ipv6networkaddr> | dhcpv6_client [enable | disable] }
<ip_addr>
<ipv6addr>
default <ipaddr>
{default}
{ <ipaddr> | static }
82
D-Link Web Smart Switch User Manual

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents