Opt Unit Assy And Lamp Assy Removal; Ps Con Aperture (Vpl-Ex1) And S In-Polarizer (R), (G), (B) Removal - Sony VPL-CS5A Service Manual

1-3-10. Opt Unit Assy and Lamp Assy Removal

To remove the opt unit assy and lamp assy, remove C board and the DC fan beforehand.
4 Four screws
(+P M4x12)
2 Connector
5 Opt unit assy

1-3-11. PS Con Aperture (VPL-EX1) and S In-polarizer (R), (G), (B) Removal

8 Three screws
(+B 2 x 6)
9 S In-polarizer (G)
assy
0 S In-polarizer (R)
assy
!- S In-polarizer (B)
assy
5 P/S assy
Note : Do not disassemble the opt unit unless
VPL-CS5A/CS6/CX6/EX1
1 Two screws
(+PWHTP 3 x 10)
(Lamp)
1 Two screws
(+B 2 x 6)
specified by the above views.
3 Two screws
(+B 3 x 6)
Opt unit assy
2 Unit cover (B), Six cushions
6 PS con aperture
(VPL-EX1)
7 Lens-2 fly eye
4 Lens-1 fly eye
Note when installing:
(For the VPL-EX1, the protruded portion
should be installed in the Lens-2 fly eye side.)
(For the VPL-CS6/CX6/CS5A, the protruded portion
should be installed in the UV-cut pre-filter side.)
3 UV-cut pre-filter
Opt unit assy
6 Lamp house,
Lamp top cover
7 Lamp assy
1-7