Rear Panel - Sony MVS-6000-C Operation Manual

Rear Panel

qfOUTPUTS 1 to 24 and FC 1, 2 connectors
qdMONITOR OUT 25 to 32 connectors
qsPRIMARY INPUTS 1 to 49 connectors
qaREF INPUT connectors
0DATA connector
9FM DATA connector
8CTRL connector
a - AC IN (AC power input) A and B connectors
(3-pin)
Connect to 100 to 240 V AC power supply with the
optional AC power cords.
Depending on the configuration of your unit when
shipped, the HK-PSU04 Power Supply Unit may not be
installed. In that case, the AC IN B connector is not used.
Note
For information about installing an HK-PSU04 Power
Supply Unit, contact your Sony service representative.
b U (signal ground) terminal
Connect to the system ground.
c FM (frame memory) DEVICE connector
(IEEE1394 compliant)
This connector is for attaching an external hard disk drive
for frame memory.
For details of hard disk drives that can be used with the
MVS-6000 system, consult your Sony service
representative.
d GPI (General Purpose Interface) connector (D-sub
25-pin)
Connect to external devices for input and output of trigger
signals. Up to eight inputs and eight outputs are possible,
with input and output conditions set on the center control
panel.
e REMOTE 1 to 4 connectors (D-sub 9-pin, RS-422A
compliant)
These connectors are used to control the auxiliary bus of
the MVS-6000 series from external devices, or to operate
the MVS-6000 from editing control systems such as the
BVE-9100.
1-AC IN A and B connectors
2U terminal
3FM DEVICE connector
4GPI connector
5REMOTE 1 to 4 connectors
6DME CTRL connector
7DME DATA connector
Define the types of the connected devices on the center
control panel.
f DME CTRL (Digital multi effect control)
connector (RJ-45 compliant) (MKS-6470)
Connect to an Ethernet switch.
*
The MVS-6000 system's center control panel is connected
in the same way to the Ethernet switch to form a network
for exchange of signals between the devices.
This network is used primarily to control the various
devices from the center control panel of the MVS-6000
system.
g DME DATA (Digital multi effect data) connector
(RJ-45 compliant) (MKS-6470)
Connect to an Ethernet switch.
*
The MVS-6000 system's center control panel is connected
in the same way to the Ethernet switch to form a network
for exchange of signals between the devices.
h CTRL (control) connector (RJ-45 compliant)
*
Connect to an Ethernet switch.
The MVS-6000 system's center control panel is connected
in the same way to the Ethernet switch to form a network
for exchange of signals between the devices.
This network is used primarily to control the various
devices from the center control panel of the MVS-6000
system.
i FM DATA (frame memory data) connector (RJ-45
compliant)
Connect to an Ethernet* switch. This is a dedicated LAN
connector for image data.
j DATA connector (RJ-45 compliant)
Connect to an Ethernet* switch.
Location and Function of Parts
9