Rear Panel - Sony MVS-8000G-C Operational Manual

Rear Panel

MVS-8000G
qdMONITOR OUT 49 to 56 connectors
qsDME 2B, 2A, 1B, and 1A connectors
qaPRIMARY INPUTS 1 to 80 connectors
0OUTPUTS 1 to 48 and FC
1 to 4 connectors
9REF INPUT connectors
8DATA connector
7CTRL connector
MVS-8000GSF
0OUTPUTS 1 to 24 and FC 1, 2 connectors
qsDME 1B and 1A connectors
qaPRIMARY INPUTS 1 to 34 connectors
9REF INPUT connectors
8DATA connector
7CTRL connector
a - AC IN (AC power input)
A, B, C, and D connectors (3-pin): MVS-8000G
A, B connectors (3-pin): MVS-8000GSF
Connect to 100 to 240 V AC power supply with the
optional AC power cords.
MVS-8000G: Depending on the configuration of your unit
when shipped, the HK-PSU04 Power Supply Unit may
not be installed. In that case, the AC IN C and AC IN
D connectors are not used.
MVS-8000GSF: Depending on the configuration of your
unit when shipped, the HK-PSU04 Power Supply Unit
may not be installed. In that case, the AC IN B
connector is not used.
Note
For information about installing an HK-PSU04 Power
Supply Unit, contact your Sony service representative.
b U (signal ground) terminal
Connect to the system ground.
c FM (frame memory) DEVICE connector
(IEEE1394 compliant)
This connector is for attaching an external hard disk drive
for frame memory.
For details of hard disk drives that can be used with the
MVS-8000G system, consult your Sony service
representative.
d GPI (General Purpose Interface) connector (D-sub
25-pin)
Connect to external devices for input and output of trigger
signals. Up to eight inputs and eight outputs are possible,
with input and output conditions set on the center control
panel.
1 - AC IN A, B, C,
and D connectors
2 U terminal
3FM DEVICE connector
4GPI connector
5FM DATA connector
6REMOTE 1 to 4 connectors
1 - AC IN A, B
connectors
2 U terminal
3FM DEVICE connector
4GPI connector
5FM DATA connector
6REMOTE 1 to 4 connectors
Location and Function of Parts
11