Specifications - Makita HM1202 Instruction Manual

ENGLISH
1. Switch lever
2. Adjusting dial
3. Power-ON indicator lamp (green)
4. Service indicator lamp (red)
5. Side handle
6. Clamp nut
7. Side handle base
8. Bit grease

SPECIFICATIONS

Model
Blows per minute
Overall length
Net weight
Safety class
• Due to our continuing program of research and development, the specifications herein are subject to change without
notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2003
Symbols
The following show the symbols used for the equipment.
Be sure that you understand their meaning before use.
.... Read instruction manual.
.............. DOUBLE INSULATION
Intended use
The tool is intended for chiselling work in concrete, brick,
stone and asphalt as well as for driving and compacting
with appropriate accessories.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and can
only be operated on single-phase AC supply. They are
double-insulated and can, therefore, also be used from
sockets without earth wire.
For public low-voltage distribution systems of
between 220 V and 250 V.
Switching operations of electric apparatus cause voltage
fluctuations. The operation of this device under
unfavorable mains conditions can have adverse effects to
the operation of other equipment. With a mains
impedance equal or less than 0.46 Ohms it can be
presumed that there will be no negative effects. The
mains socket used for this device must be protected with
a fuse or protective circuit breaker having slow tripping
characteristics.
4
Explanation of general view
9. Bit shank
10. Bit
11. Tool holder cover
12. Change ring
13. Commutator
14. Insulating tip
15. Carbon brush
16. Screwdriver
HM1202
1,900 min
9.9 kg
END201-5
General Power Tool Safety
Warnings
instructions. Failure to follow the warnings and
instructions may result in electric shock, fire and/or
serious injury.
Save all warnings and
instructions for future reference.
ENE045-1
The term "power tool" in the warnings refers to your
mains-operated (corded) power tool or battery-operated
(cordless) power tool.
Work area safety
ENF002-2
1. Keep work area clean and well lit. Cluttered or dark
2. Do not operate power tools in explosive
3. Keep children and bystanders away while
ENF100-1
Electrical safety
4. Power tool plugs must match the outlet. Never
5. Avoid body contact with earthed or grounded
17. Rear cover
18. Screws
19. Brush holder cap
20. Socket wrench
21. Crank cap
22. Hammer grease
-1
578 mm
/II
WARNING! Read all safety warnings and all
areas invite accidents.
atmospheres, such as in the presence of
flammable liquids, gases or dust. Power tools
create sparks which may ignite the dust or fumes.
operating a power tool. Distractions can cause you
to lose control.
modify the plug in any way. Do not use any
adapter plugs with earthed (grounded) power
tools. Unmodified plugs and matching outlets will
reduce risk of electric shock.
surfaces such as pipes, radiators, ranges and
refrigerators. There is an increased risk of electric
shock if your body is earthed or grounded.
HM1202C
-1
950 - 1,900 min
10.0 kg
GEA005-3