Advertisement
4.Assembling on the housing
1) To assemble the one body of gear assembly and motor etc. on the housing L, place the speed change lever
on the position shown on the figure 5.
Inside of Housing "L"
5.Assembling of the chuck
1) Place the chuck on the spindle face.
2) Mount the hexagon rod spanner on the chuck and use the vice to fix them.
3) Set to the drill mode, normal turning and low speed.
4) Set the full charged battery and securely hold the handle.*1
5) Allow the trigger to full speed in about 1 second while no impact is adding.
*Insufficiently holding the handle may cause the handle to turn around in locking. This machine is going
to turn clockwise.
6) Widen the claw of chuck at maximum and then fasten the screw for holding the chuck.
*The left-handed screw is used.
C
ircuit drawing
Fig. 5
Red mark
Black
Red
DC motor
- terminal
+ terminal
Lever should be left light position,
not nuetral position
Switch
Advertisement
