Troubleshooting - Pioneer BD-V3500HD Series Operating Instructions Manual

Cable TV Reception
STEP
Plug the AC cords into AC outlets
4
that are not controlled by a switch.
NOTE:
When disconnecting the BD-V3500HD, follow
these steps in reverse order. Be sure to unplug
the BD-V3500HD's power cord first.
SETTING UP THE TV
Follow the steps in the table to set up your TV for
cable.
STEP
Turn the BD-V3500HD and the TV
1
on.
Select the correct input on the TV:
video/audio, S-Video, Y-Pb-Pr
(component video), or DVI (digital
2
video), depending on how you
have connected it.
Press SETTINGS on the remote
control, and use the resolution/
aspect ratio setting menus to select
3
the setting that appears properly
on your TV. The steps to follow
may appear in a separate manual
from your cable company.
Use your remote control's TV
4
POWER button to turn the TV on
and off.
TURNING OFF THE BD-V3500HD
To turn off the BD-V3500HD home terminal, press
the CBL POWER button on the remote control, or
the POWER button on the BD-V3500HD.
You can use your remote's TV POWER button to
turn the TV on/off if you have set up the remote
with the correct TV code.
VCR RECORDING
The BD-V3500HD has an optional IR CONTROL.
Please refer to the IR CONTROL CABLE instruction
manual.
BRE1019C_En_02_10.pm6
ACTION
ACTION
9

TROUBLESHOOTING

NO TV PICTURE?
Use the checklist in the table if you followed all the
instructions but still do not see a picture on your
television.
ACTION
Is cable service connected to
1 BD-V3500HD CABLE
connector?
Is a cable connected between
BD-V3500HD VIDEO and L/R
2
AUDIO output connectors and
TV VIDEO and L/R AUDIO input
connectors?
Is the BD-V3500HD AC cord
plugged in to an unswitched
3
AC outlet?
Are both BD-V3500HD and TV
4
turned on?
Has the correct A/V or digital
input been selected on the TV?
5
If no picture on one input, try
the others.
No video on Y-Pb-Pr outputs?
Make sure the Digital Video
6
Output is not connected to a
TV. When connected, the Y-
Pb-Pr outputs are switched off.
03.1.7, 1:37 PM
CHECK
IN
9