Commands - D-Link DES-1228/ME Reference Manual

The Switch implements IEEE 802.1X Port-based and Host-based Access Control. This mechanism is intended to allow only
authorized users, or other network devices, access to network resources by establishing criteria for each port on the Switch that a
user or network device must meet before allowing that port to forward or receive frames. The 802.1X commands in the Command
Line Interface (CLI) are listed (along with the appropriate parameters) in the following table:
Command
enable 802.1x
disable 802.1x
show 802.1x
config 802.1x capability ports
config 802.1x auth_parameter ports
config 802.1x auth_protocol
config 802.1x init
config 802.1x auth_mode
config 802.1x reauth
config radius add
config radius delete
config radius
config radius parameter
show radius
create 802.1x guest_vlan
config 802.1x guest_vlan ports
delete 802.1x guest_vlan
show 802.1x guest_vlan
show auth_statistics
show auth_diagnostics
show auth_session_statistics
show auth_client
show acct_client
create 802.1x user
delete 802.1x user
show 802.1x user
DES-1228/ME Metro Ethernet Managed Switch CLI Reference Guide
Parameters
[auth_state | auth_configuration ] {ports <portlist>}
[<portlist> | all] [authenticator | none]
[<portlist> | all] [default | {direction [both | in] | port_control [force_unauth |
auto | force_auth] | quiet_period <sec 0-65535> | tx_period <sec 1-65535> |
supp_timeout <sec 1-65535> | server_timeout <sec 1-65535> | max_req
<value 1-10> | reauth_period <sec 1-65535> | enable_reauth [enable |
disable]}] (1)
[local |radius_eap]
[port_based ports [<portlist> | all>] | mac_based ports [<portlist> | all]
{mac_address <macaddr>}]
[port_based | mac_based]
[port_based ports [<portlist> | all] | mac_based ports [<portlist> | all]
{mac_address <macaddr>}]
<server_index 1-3> [<server_ip> key <passwd 32> [default | {auth_port
<udp_port_number 1-65535> | acct_port <udp_port_number 1-65535>}](1)
<server_index 1-3>
<server_index 1-3> {ipaddress <server_ip> | key <passwd 32> [auth_port
<udp_port_number 1-65535> acct_port <udp_port_number 1-65535>]}(1)
{ timeout <int 1-255> | retransmit <int 1-255>} (1)
{<vlan_name 32>}
[<portlist> | all] state [enable | disable]
{<vlan_name 32>}
{ports <portlist>}
{ports <portlist>}
{ports <portlist>}
<username 15>
<username 15>
802.1X C
192
21
OMMANDS