Card Id Registration - Canon imageRUNNERC1022 Service Manual

Chapter 2
6) Install the panel mount cover [1] removed in step 4.
- 1 claw [2]
- 1 screw [3] (The screw removed in step 4 is used.)
CAUTION:
Be sure to route the card reader cable [4] through the cut-off [5] of the panel
mount cover to prevent the cable from being caught.
2-10
[1]
[1]
F-2-25
[5]
[4]
[1]
[3]
[2]
F-2-26
7) Install the 2 case connectors [1].
CAUTION:
When installing the case connectors, be sure to place the tie-wraps [2]
inside of the case connectors [1].
[1]

2.5.5 Card ID Registration

imageRUNNER C1022 / imageRUNNER C1022i / Color imageRUNNER
C1030 / Color imageRUNNER C1030iF
CAUTION:
Be sure to enter the card number to use in service mode of the host machine
after installing the Card Reader. If the number is not entered, the card is not
recognized when being inserted.
NOTE:
When "System Manager Information Settings" is set, be sure to follow the
direction of user administrator in order to log in as an administrator.
1) Connect the power plug to the power outlet and turn on the main power
switch.
2) Specify the first number of the card ID to register.
- COPIER > OPTION > ACC > CARD
- The serial numbers beginning the specified one are automatically
registered in Dept. ID for 1000 cards.
- Exit service mode after registration.
3)-1. Select the following; [Additional Func.] > [System Management Set.]
> [Dept. ID Management] > ON, and press the OK key.
NOTE:
Implement the procedure below to check the registration although card ID
registration is complete by performing step 1 to 3.
3)-2. Press 'Back' key or 'Done' key to display the [System Mgmt. Dept. ID
and Password] screen.
3)-3. Select [System Mgmt. Dept. ID:], press the OK key, enter the numeric
characters registered in step 2, and then press the OK key.
[1] [2]
[2]
F-2-27
0019-8712