Components (Rear); Figure 1.16 3.5" Drives; Figure 1.17 Drive Slot Numbers (Drive Enclosure); Table 1.6 Status And Meanings Of Each Led (Drive (Drive Enclosure)) - Fujitsu ETERNUS DX60 S3 Operating Instructions Manual

Chapter 1 Component Name/LED Name
1.2 3.5" Type Drive Enclosure
■
Drives
Figure 1.16 shows the 3.5" drive.
Table 1.6 shows the status and meanings of each LED.

Figure 1.16 3.5" Drives

1. DRIVE READY LED
2. DRIVE FAULT LED

Figure 1.17 Drive Slot Numbers (Drive Enclosure)

The LEDs turn on or blink to indicate the statuses that are listed below.

Table 1.6 Status and Meanings of Each LED (Drive (Drive Enclosure))

LED name
DRIVE READY
DRIVE FAULT
1.2.4

Components (Rear)

This section describes the I/O modules and the power supply units in the rear of the drive enclosure.
■
I/O Modules
The I/O module is a component that controls how the controller and the drives interact.
Figure 1.17
1
2
Slot#8 Slot#9
Slot#4 Slot#5
Slot#0 Slot#1
LED status
(green)
(blinks green)
(amber)
FUJITSU Storage ETERNUS DX60 S3 Disk storage system Operation Guide (Basic)
Copyright 2014 FUJITSU LIMITED
shows the slot number of each 3.5" drive.
Slot#10
Slot#6
Slot#2
Meanings
The drive is in normal status.
The drive is in error status.
•
• In response to commands from ETERNUS CLI, the location of
the drive is identified.
25
Slot#11
Slot#7
Slot#3
P3AM-9012-01ENZ0