Makita 2414NB Instruction Manual page 7

Interval between vise and guide plate
The original spacing or interval between the vise and the guide plate is 0
-
170 mm
(0
-
6-1 1/16"). If your work requires wider spacing or interval, proceed as follows to change
the spacing or interval.
Remove the two hex bolts which secure the guide plate. Move the guide plate as shown
in the figure and secure it using the hex bolts. The following interval settings are possible:
35
-
205 mm (1-3/8"
-
8-1/16")
70
-
240 mm (2-3/4"
-
9-7/16")
I
I t
Hex bolts
CAUTIO N :
Remember that narrow workpieces may not be secured safely when using the two, wider
interval settings.
Setting for desired cutting angle
To
change the cutting angle, loosen the
two hex bolts which secure the guide plate.
Move the guide plate to the desired angle
(0'
-
45") and tighten the hex bolts secure-
ly.
CAUTION:
Socket wrench
Never perform miter cuts when the guide plate
is
set at the 35
-
205 mm (1-3/8"
-
8-1/16") or 70
-
240 mm (2-3/4"
-
9-7/16") position.
7