Powering On; Switching On And Off The Main Line Switch On The Power Distribution Unit; Figure 5.3 Pc Terminal Connection For Initial Setup; Figure 5.4 On Position (Marked "|") Of The Main Line Switches On A 1U Power Distribution Unit - Fujitsu ETERNUS DX60 S3 Configuration Manual

Chapter 5 General Settings
5.2

Powering On

The ETERNUS DX and the PC terminal must be connected directly since the network environment of the
ETERNUS DX is set using the PC terminal for the initial setup of the ETERNUS DX.

Figure 5.3 PC Terminal Connection for Initial Setup

PC terminal
Controller
enclosure
5.2 Powering On
This section explains how to turn on the ETERNUS DX.
5.2.1

Switching On and Off the Main Line Switch on the Power Distribution Unit

Turn the main line switch of the power distribution unit to the ON position (marked "|").
Make sure all of the main line switches are in the ON position.
●
For 1U

Figure 5.4 ON Position (Marked "|") of the Main Line Switches on a 1U Power Distribution Unit

Main line switch
LAN port
LAN cable
RMT port of Controller 0 (CM#0)
FUJITSU Storage ETERNUS DX60 S3 Disk storage system Configuration Guide (Basic)
Copyright 2014 FUJITSU LIMITED
58
P3AM-9002-01ENZ0