Chapter 4 Connecting Cables; Host Interface Cable Connection - Fujitsu ETERNUS DX60 S3 Configuration Manual

Chapter 4
Connecting Cables
This chapter explains how to connect various cables to the ETERNUS DX.
4.1

Host Interface Cable Connection

Connect the ETERNUS DX to the connection destination using host interface cables. The connection procedure
varies depending on the type of host interface that is used for the ETERNUS DX.
Prepare the same number of host interface cables as the number of host interface ports.
This section uses an iSCSI 1Gbit/s host interface (CA) as an example to show the connection procedure.
To help with host interface cable management and prevent incorrect connections, attach labels to the
•
cables that show which end is for the connection origin and which end is for the connection destination.
When connecting a host interface cable, check the direction of the connector tab and insert it all the
•
way in firmly.
When disconnecting a host interface cable, pull out the connector while holding its tab.
If the host interface ports and host interface cable connectors have covers, remove the covers. Keep the
•
removed covers in a safe place where they will not be lost.
When connecting the cables, position them so that they will not obstruct replacement of the power sup-
•
ply unit or controllers by the maintenance engineer.
This section uses a controller enclosure with two controllers as an example to explain the connection pro-
cedure. When one controller is installed, this procedure is only applied to Controller 0 (CM#0).
Do
Wear a wrist strap or touch a metal part to discharge the human body's natural
•
static electricity before starting each operation. Failure to discharge static electrici-
ty may cause failure in the ETERNUS DX.
FUJITSU Storage ETERNUS DX60 S3 Disk storage system Configuration Guide (Basic)
Copyright 2014 FUJITSU LIMITED
46
P3AM-9002-01ENZ0