Vent Assembly/Smoke Eliminator; Oven Door Hinge; Frameless Door Disassembly - Maytag AEW3530DD Series Service Manual

Disassembly Procedures
!

Vent Assembly/Smoke Eliminator

1. Turn power off to unit.
2. Open oven door and remove screws securing unit to
the wall.
3. Remove oven from cutout opening.
4. Disconnect or unplug the power cord leading from unit
to fuse box or junction box depending on unit.
5. Remove screws securing top and back outer wrapper
from the unit.
6. Remove screws securing vent assembly to outer
cabinet top wrapper.
7. Raise back of vent assembly and slowly maneuver
vent assembly away from unit.
8. Remove screws securing smoke eliminator, located
inside oven on top of oven cavity.
9. Reverse procedure to reinstall.

Oven Door Hinge

1. Turn off power to unit.
2. Remove oven door, see "Door Removal".
3. Remove control panel, see "Control Panel Assembly"
procedure, steps 1 through 3.
4. Remove the top and bottom screws securing hinge
assembly to the front frame.
5. Remove hinge from oven chassis.
6. Replace and reverse procedure to reassemble oven
door hinge.
30
WARNING
16022506 Rev. 0
To avoid risk of electrical shock, personal injury or death;
disconnect power to unit before servicing.

Frameless Door Disassembly

1. Remove oven door, see "Oven Door Removal"
procedure.
2. Place door on a protected surface.
3. Remove screws securing bottom trim to oven door.
4. Slide outer oven door glass and trim towards the
bottom of the oven door and remove.
5. Detach right and left trim pieces for outer door glass.
NOTE: Proceed with the following steps for door hinge,
door handle, and inner door disassembly.
6. Remove screws securing door hinge to oven door
chassis.
NOTE: Proceed with the following steps for door handle
and inner door disassembly.
7. Remove screws securing top door handle trim to oven
door chassis.
8. Remove screws securing door handle brackets to
inner door panel.
9. Lift upward on the lower side of the door handle to
release side alignment screws and rotate towards the
top of the oven door to release and remove.
10. Remove screws securing door handle to door handle
brackets.
NOTE: Proceed with the following steps for inner door
disassembly.
11. Remove screws securing lower door glass retainer to
door baffle and remove.
12. Slide inner door glass downward to release from upper
door glass retainers and remove.
13. Remove screws securing door baffle to door lining and
remove.
14.Remove insulation from oven door.
15. Lift inner glass and glass frame from oven door.
16. Reverse procedure to reassemble oven door.
©2003 Maytag Appliances Company