NETGEAR GS308 Installation Manual

GS308_IG.fm Page 1 Tuesday, July 31, 2012 6:22 PM
Gigabit Ethernet Switch GS308
Estimated installation time: 5-10 minutes

Package Contents

This package includes:
• Gigabit Ethernet Switch GS308
• AC power adapter
• Installation Guide (this document)
Installation Guide
Prepare to Install the Switch
Place the switch on a flat horizontal surface such as a table,
desk, or shelf. You can use wall-mounting screws (not provided)
to hang the switch in an open space on a wall.
Make sure the selected location is:
• Not in direct sunlight or near a heater or heating vent.
• Not cluttered or crowded. There must be at least 2 inches
(5 cm) of air space on all sides of the switch.
• Well ventilated (especially if it is in a closet).
You need a Category 3 (10 Mbps), Category 5 (100 Mbps), or
Category 5e (1000 Mbps) Ethernet cable with RJ-45 connectors
for each device you connect to the switch. Each Ethernet cable
must be less than 328 feet (100 meters).
Install the Switch and Connect Devices
1. Place the switch on a flat surface or hook it onto the screws.
2. For each device, insert one end of an Ethernet cable into a
port on the switch and the other end into the network port
on the device.
3. Connect the power adapter cord into the back of the switch
and then plug the adapter into a power source (such as a
wall socket or power strip).
Firewall
GS308 8-Port
Gigabit switch
4. Check the LEDs:
Power
• Verify that the Power LED is lit.
• For each RJ-45 jack that is connected to a powered
device, check that the Link LED is lit, and it flashes when
activity occurs.
Note: If any LED does not operate as indicated go to the
Troubleshooting section.
Modem