Troubleshooting - Black & Decker BDPH400 Instruction Manual

tROUBlE! mAtERIAl RUNS OR DRIPS.
WhAt'S WRONG?
Spraying too much material.
Spraying too slowly.
Spraying too close.
Viscosity too thin.
tROUBlE! tOO mUCh OvER SPRAY.
WhAt'S WRONG?
Sprayer too far from surface.
Too much material being sprayed.
tROUBlE! lIttlE OR NO mAtERIAl BEING RElEASED.
WhAt'S WRONG?
Check valve ball stuck
Spray nozzle/tip clogged.
Pickup tube loose or clogged.
Air hose split or disconnected
Flow control knob setting too low.
Air inlet blocked
Material too thick.
tROUBlE! mAtERIAl BEING SPRAYED IS SPlAttERING.
WhAt'S WRONG?
Viscosity of material is too high.
tROUBlE! SPRAYER PUlSAtES.
WhAt'S WRONG?
Air filter clogged
Material in canister almost empty.
tROUBlE! lIQUID COmES OUt SIDE OF CANIStER.
WhAt'S WRONG?
Lid not on square or tight enough.
Paint on threads of canister and lid.
tROUBlE! CANNOt DEPRESS tRIGGER tO StAR SPRAYING
WhAt'S WRONG?
Flow control setting is set complelely to the minimum side.

tROUBlEShOOtING

WhAt tO DO...
Reduce air flow by turning material adjustment knob.
Increase speed of application.
Increase distance from surface.
Check dilution recommendation.
WhAt tO DO...
Reduce distance to surface.
Reduce air flow by turning flow control knob
WhAt tO DO...
Depress ball to loosen. Add lubricant. See Fig. Q.
Clean nozzles.
Check tube.
Check air hose
Increase flow control setting
Clean or change air filter
Check viscosity recommendation
WhAt tO DO...
Thin material per manufacturer recommendation.
WhAt tO DO...
Clean or change air filtre.
Refill canister.
WhAt tO DO...
Remove lid and reattach squarely and evenly, then tighten lid
securely.
Clean threads on top and sides of canister and lid.
WhAt tO DO...
Back the flow control knob off (clockwise) to allow for more
trigger travel.
ENGLISH • 27