Connecting The Bathroom Speakers - Samsung 890 Series Installation Manual

You can connect the Bathroom Speakers in the following manner.
Connecting through the Variable Output (available without an external amplifier)
¦
TV Rear Panel
1. Connect the VARIABLE AUDIO OUT
Speaker +
Speaker -
✎
The VARIABLE AUDIO OUT
✎
Speaker Wire: Use speaker cable no more than 82 feet (25m) in length.
✎
The maximum speaker output is 4W, 8Ω.
2. Connect the VOL-CTRL
VOL - UP
VOL - DOWN
( White 1 ) ( Black /Red 2 )
y Installing the Volume Control
– If you configure the Volume Control Box as shown in the figure above, you can control the volume of the bathroom
speakers.
– The jack that connects the Volume Control Box to the TV is a 3.5mm normal Phone jack.
– Volume Control Box switch is a Tact switch.
3. Set the Sub AMP Mode
– 0: Deactivates the sub amplifier that outputs the voice signal of
VARIABLE AUDIO
– 1: Adjusts the voice output of
for the Hotel mode menus of Power On Volume Num, Min Volume, and Max Volume apply to the TV, speakers, and
VARIABLE AUDIO
– 2: Determines the volume according to the bathroom control panel setting.
[HC890_ZA]Install_Guide_00ENG.indd 21

Connecting the Bathroom Speakers

1
2
port of the TV to the Bathroom Wall Speakers of the hotel.
N/C
port supports MONO sound out only.
jack of the TV to the Volume Control Box Switch port on the Bathroom Wall of the hotel.
GND
( Shield Wire 3 )
OUT.
VARIABLE AUDIO OUT
OUT.
Volume Control Box
VOL +
1
3
2
VOL -
VARIABLE AUDIO OUT. No voice signal is output from
according to the volume level of the TV speaker. And all settings
Speaker
VOL+
Volume Control Box
VOL-
21
English
2014-04-02 1:39:19