Disk Partition Settings - Fujitsu ETERNUS DX200F Configuration Manual

Chapter 8 SAN Connection Settings
8.2 Server Connection Setup
8.2.3

Disk Partition Settings

Set up disk partitions to use the specified LUNs for the ETERNUS DX.
The volumes are recognized as disks in order, starting from the volume that is set for LUN0.
For example, if LUN0 is recognized as Disk 1, LUN1 is recognized as Disk 2 and LUN2 as Disk 3.
Perform the settings as shown below.
Drive
F
G
H
I
J
K
L
M
*1: The capacity that is displayed in "( )" is the copy source capacity.
For the operation volume (Standard), perform
tings" (page 108).
For the volume for generation copy (Snap Data Volume), perform
111) in "8.2.3.2 Disk Settings" (page
8.2.3.1 Disk Recognition
The following procedure explains how to create a disk partition.
1
Open [Disk Management] via [Computer Management].
2
If the [Initialize Disk] screen appears, confirm that all the disks are selected and click the [OK] button.
Then proceed to
Select the checkbox for eight disks in this example.
When Windows Server 2008 Enterprise is used, [Initialize Disk] does not appear. Perform the steps from
Step 3 onwards.
File system
that is to be LUN
created
NTFS 0
RAW 1
RAW 2
RAW 3
RAW 4
RAW 5
RAW 6
RAW 7
108).
Step 6.
FUJITSU Storage ETERNUS DX200F All Flash Array Configuration Guide (Basic)
Copyright 2014 FUJITSU LIMITED
Volume No. Volume name
0 main
1 sdv0
2 sdv1
3 sdv2
4 sdv3
5 sdv4
6 sdv5
7 sdv6
"■ Operation Disk Settings" (page 108)
"■ SnapOPC+ Destination Settings" (page
104
Type Capacity (*1)
Standard 1TB
SDV (1TB)
SDV (1TB)
SDV (1TB)
SDV (1TB)
SDV (1TB)
SDV (1TB)
SDV (1TB)
in "8.2.3.2 Disk Set-
P3AM-8462-01ENZ0