NETGEAR XAV1101 Installation Manual

LEDs and Button Descriptions
Power LED
Ethernet LED
Powerline LED
Security button
Reset button
LED Description
Power • Solid green. The electrical power is on.
LED • Blinking green. The adapter is in power saving mode or
setting up security.
• Off. There is no electrical power.
Ethernet • Solid. The Ethernet port is linked, but there is no activity.
LED • Blinking. There is traffic on the Ethernet port.
• Off. There is no Ethernet connection.
Power- • Solid. The adapter is connected to a Powerline network.
line LED • Blinking. The adapter is sending or receiving data.
• Off. The adapter has not found any other compatible
Powerline devices using the same encryption key.
The Pick A Plug feature lets you pick the electrical
outlet with the strongest link rate, indicated by the color
displayed by the LED
Green: Amber: Red:
Link rate Link rate > 50 Link rate
> 80 Mbps and < 80 Mbps < 50 Mbps
(Best) (Better) (Good)
The Reset and Security buttons are located on the bottom.
• Reset button. Press the Reset button for 1 second,
and then release it to return the Powerline adapter to
its factory default settings.
• Security button. After you plug in your new adapter,
press the Security button for 2 seconds, and then
press the Security button on one of the other adapters
in your network for 2 seconds. Both buttons must be
pressed within 2 minutes.
Note: The Security button does not work in power
saving mode (see "Power LED blinks once every 3
seconds" in the "Troubleshooting Tips.")
Warning: Do not press the Security button on the
Powerline adapter until installation is complete and the
adapters are communicating with each other (indicated by
the blinking Powerline LED). Pressing this button too soon
can temporarily disable Powerline communication. If this
occurs, use the Reset button to return the Powerline
adapter to its factory default settings.

Troubleshooting Tips

Power LED is off. Make sure that power is supplied to the electrical outlet,
and that the Powerline devices are not plugged into an
extension cord, power strip, or surge protector.
Power LED The adapter is in power saving mode and the Ethernet
blinks once every LED is off. This can occur when:
3 seconds. • The Ethernet cable is unplugged.
• The Ethernet-connected device is turned off.
• The adapter is idle for 10 minutes.
The adapter returns to normal mode within 2 seconds
once the Ethernet link is up.
Powerline LED is • If you have set network security, make sure that all
off. Power line devices are using the same encryption key;
see the online User Manual for details.
• Press the Reset button on each device for 1 second to
return the Powerline adapter to its factory default
settings.
Powerline LED is Move the Powerline device to a closer location.
amber or red.
Ethernet LED is • Make sure that the Ethernet cables are working and
not blinking. securely plugged into the devices.
• Press the Reset button on each device for 1 second to
return the Powerline adapter to its factory default
settings.
This symbol was placed in accordance with the European Union
Directive 2002/96 on the Waste Electrical and Electronic Equipment
(the WEEE Directive). If disposed of within the European Union, this
product should be treated and recycled in accordance with the laws
of your jurisdiction implementing the WEEE Directive.
© 2011 by NETGEAR, Inc. All rights reserved. NETGEAR and the NETGEAR
logo are registered trademarks of NETGEAR, Inc. in the United States and/or
other countries. Other brand and product names are trademarks or registered
trademarks of their respective holders. Information is subject to change without
notice.
Powerline AV 200 Mini Adapter XAV1101
Package Contents
Powerline AV 200
Mini Adapter
Ethernet Cable
April 2011
Installation Guide