Front Fork Installation - Yamaha SR125 1997 Service Manual

FRONT FORK
7. Measure:
: Oil level a
Out of specification ! Adjust.
Oil level:
165 mm
(from the top of the inner tube
fully compressed and without
the fork spring)
NOTE:
Hold the fork in an upright position.
8. Install:
: Front fork spring 1
NOTE:
: Install the fork spring with its smaller pitch up-
ward.
: Before installing the cap bolt, apply grease to
the O-ring.
: Temporarily tighten the cap bolt.
9. Install:
: Plate washer
: Spacer
: O-ring
New
: Cap bolt
EB70307250

FRONT FORK INSTALLATION

Reverse the "REMOVAL" procedure.
Note the following points.
1. Install:
: Front fork 1
: Plate washer 2
Temporary tighten the pinch bolts.
NOTE:
Pull up the inner tube until its end flushes the top
of the under bracket, then temporarily tighten
the bolt (under bracket lower).
2. Tighten:
: Cap bolts 3
: Pinch bolts (under bracket)
6-34
CHAS
65 Nm (6.5 m:kg)
48 Nm (4.8 m:kg)
30 Nm (3.0 m:kg)