KitchenAid KSS1121 Instructions Manual page 16

Sparkling beverage maker
Hide thumbs Also See for KSS1121:
Table of Contents

Advertisement

Available languages

Available languages

IHPORTANT:
Before you call for service, check the list of problems and solutions
below:
I. Sparkling
Beverage
Haker
does
not work:
• You might be out of C02; replace your
C02 Carbonator
by exchanging it for a
full SodaStream 60 L C02 Carbonator.
• Check that the carbonating
bottle has
been filled up with water
to the fill line.
• Ensure
that the Sparkling
Beverage
Maker
is always
in the upright
position.
" CO2 Carbonator
may be loose.
Do
not use tools.
Detach
the bottle,
open
the rear cover, and retighten
the CO2
Carbonator.
Apply firm pressure
but do
not over tighten.
If the CO2 Carbonator
is already
firmly in place,
it may be empty.
Replace
with a full 60 L SodaStream
CO_
Carbonator.
_WARN|NG:
Use caution
when removing
carbonator
as it may be very cold.
2. Cannot
pull bottle
loader
tab:
• Make sure carbonation
lever is in its fully
upward
position.
• Pull bottle
loader
tab firmly towards
you.
3. Cannot
install the carbonating
bottle:
• Make sure the carbonation
lever is in its
fully upward
position.
• Pull the bottle
loader
tab toward
you
until it clicks.
• Insert bottle
into Snap-Lock
• Push bottle
up and back until it locks.
4. You hear
CO2 escaping
from
the
bottle
during
carbonation:
• Bottle may not be properly
attached.
Allow the Sparkling
Beverage
Maker
to finish the carbonation
process
and
then you can detach
the bottle
and
reconnect
it following
the instructions
in the "Making sparkling
water"
section.
• It is normal to hear a small amount
of CO2 discharge
at the end of the
carbonating
process.
5. You want
to re-carbonate
a drink
that was already
carbonated:
_WARNING:
Never carbonate
again
after you have added
the flavor. You
may recarbonate
only unflavored
sparkling
water.
6. If your
Sparkling
Beverage
Haker
continues
to release
CO2 after
carbonation
is finished:
_WARNING:
Do not remove
the cylinder
or the bottle.
Leave the Sparkling
Beverage
Maker
in an upright
position.
Do not touch
it until you no longer hear CO2 escaping.
When
the Sparkling
Beverage
Maker
is
no longer releasing
CO2, remove
the
carbonating
bottle, and call for service.
See "Warranty"
section
for more
information.
16

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

4kss1121

Table of Contents