KitchenAid KBZU122TSS Installation Instructions And Use & Care Manual page 14

Outdoor built-in dual side burners
Table of Contents

Advertisement

Available languages

Available languages

7. The tank tray for the 20 lb LP gas fuel tank must be adjusted
so that the bottom of the tank tray is
cabinet door opening and is level. The top nut on each of the
mounting brackets is to be loose. Turn the bottom nuts
counterclockwise to raise the tank tray and turn the bottom
nuts clockwise to lower the tank tray. When the tank tray is
level and slides in and out without touching the cabinet door
opening at the bottom or top with the 20 lb LP tank installed,
tighten the top nuts against the adjustment flange.
A
A. Top nut loosened
B. Top nut tightened
NOTE: A bracket or shelf (not supplied) that is large enough
to keep a second 20 lb LP gas fuel tank from being stored in
the storage area under the side burner is required to be
mounted inside the island.
Make Gas Connection
Gas Connection to a 20 lb LP Gas Fuel Tank
WARNING
Explosion Hazard
Use a new CSA International approved "outdoor"
gas supply line.
Securely tighten all gas connections.
If connected to LP, have a qualified person make sure
gas pressure does not exceed 11" (28 cm) water
column.
Examples of a qualified person include:
licensed heating personnel,
authorized gas company personnel, and
authorized service personnel.
Failure to do so can result in death, explosion, or fire.
If converting to local LP or Natural gas, follow the instructions in
the "Gas Conversions" section.
IMPORTANT: A 20 lb LP gas fuel tank must be purchased
separately.
IMPORTANT: The gas pressure regulator/hose assembly
supplied with the side burner must be used. Replacement gas
pressure regulator/hose assembly specific to your model, is
available from your outdoor side burner dealer.
14
To Install the 20 lb LP Gas Fuel Tank:
" (0.32 cm) above the
1. Open cabinet doors.
2. Pull out the tank tray.
3. Place the 20 lb LP gas fuel tank bottom collar into the
4. Tighten the locking screw against the bottom collar of the
B
5. Screw the gas pressure regulator/hose assembly to the 20 lb
6. Turn on the gas supply. Wait a few minutes for gas to move
7. Test all connections by brushing on an approved
8. Slide tank tray back into the cabinet.
9. Go to "Plug in Side Burner" in this section.
Tank tray
mounting hole in the tank tray.
20 lb LP gas fuel tank to secure.
A
A. Locking screw
B. Mounting hole
C. Bottom collar
LP gas fuel tank as shown. (To disconnect, turn off the gas
supply to the 20 lb LP gas fuel tank, then unscrew the gas
pressure regulator/hose assembly from the 20 lb LP gas fuel
tank as shown.)
connect
disconnect
A
A. 20 lb LP gas fuel tank
B. Gas pressure regulator/hose assembly
through the gas line.
noncorrosive leak-detection solution. Bubbles will show a
leak. Correct any leak found.
B
C
B

Advertisement

Table of Contents
loading

This manual is also suitable for:

Kbzu122vssKbzu242vssW10176789aKbzu242tss

Table of Contents