Cisco TelePresence System EX90 Installation Manual page 4

3
Optional: Mounting the handset
Tool: Screwdriver
A
Hold the touch screen and the handset
base in an upright position.
Move the two units together. Make sure the
connector on the handset base slides into the
corresponding hole on the touch screen.
Handset
base
C
Connect the handset to the handset
base, and connect the handset cable.
EMC Class A declaration
This is a class A product. In a
domestic environment this product
may cause radio interference in
which case the user may be required
to take adequate measures.
Touch
screen
此为A级产品，在生活环境中，该产品可能会造成无线电干扰。在这种
情况下，可能需要用户对其干扰采取切实可行的措施。
WARNING: This is a class A product. In a domestic environment
this product may cause radio interference in which case the user
B
Fasten the two units together. The screws
are pre–mounted in the handset base.
Use the screwdriver and fasten the screws at the
handset base from the underneath.
声 明