Table of Contents
Advertisement
Table 1. LEDs
LED
Power
• Solid amber. The router is starting up.
• Blinking amber. The firmware is upgrading, or the
Restore Factory Settings button was pressed.
• Solid green. The router is ready.
• Blinking green. The firmware is corrupted. See
www.netgear.com/support.
• Off. Power is not supplied to the router.
Internet
• Solid green. The Internet connection is ready.
• Solid amber. The Ethernet cable connection to the
modem has been detected.
• Off. No Ethernet cable is connected to the modem.
Wireless • Solid blue. The wireless radio is operating in either 2.4
GHz or 5 GHz mode.
• Blinking: The router is in WPS mode.
• Off. The wireless radios are off for both 2.4 GHz and 5
GHz.
USB
• Solid blue: The router has accepted the USB device. The
USB device is ready to be used.
• Blinking blue: A USB HDD is plugged in and is trying to
connect.
• Off: No USB device is connected, someone clicked the
Safely Remove Hardware button and it is now safe to
remove the attached USB device.
HDD
• Solid green: The internal HDD is working fine;
• Solid green plus red: The HDD is 85% full.
• Blinking green: Someone pressed the Backup button;
SD card data is being copied to the internal HDD.
• Blinking green and red: The HDD is 95% full.
• Solid red: The HDD is not formatted, the HDD connection
is loose, or failure alert.
• Off: No internal HDD is connected.
Description
5
Advertisement
Table of Contents
