Read Time-Out; Presentation Mode; Led Illumination - Presentation Mode - Honeywell Genesis 7580g User Manual

Read Time-Out

Use this selection to set a time-out (in milliseconds) of the scanner's trigger when using serial commands to trigger the
scanner. Once the scanner has timed out, you can activate the scanner either by pressing the trigger or using a serial trig-
ger command. After scanning the Read Time-Out bar code, set the time-out duration (from 0-300,000 milliseconds) by
scanning digits on the

Presentation Mode

Presentation Mode uses ambient light and scanner illumination to detect bar codes. When in Presentation Mode, the LEDs
remain dim until a bar code is presented to the scanner, then the aimer turns on and the LEDs turn up to read the code.
Scan the following bar code to program your Genesis device for Presentation Mode. Default = Presentation Mode.

LED Illumination - Presentation Mode

If you wish to set the illumination LED brightness, scan one of the bar codes below. This sets the LED illumination for the
scanner when it is in Presentation Mode. (If the scanner is triggered manually, the LED illumination will switch to the setting
for a manual trigger. See "LED Illumination - Manual Trigger" on page 3-5.) Default = High.
Note: The LEDs are like a flash on a camera. The lower the ambient light in the room, the brighter the LEDs need to be so
the scanner can "see" the bar codes.
Off
* High
Note: LED Illumination - Presentation Mode does not apply to
Mode.
3 - 6
Programming Chart inside the back cover, then scanning Save. Default = 30,000 ms.
Read Time-Out
* Presentation Mode
Streaming Presentation™ Mode
Low
or Mobile Phone Read