Storing Data In Pm Channels; Recalling Pm Channels - Kenwood TM-G707 Instruction Manual

STORING DATA IN PM CHANNELS

1
1 Confirm that the following conditions have been
satisfied:
2
• The transceiver is in the receive mode.
3
• Scan is not being used.
4
• Microphone Control is OFF.
5
2 Select the desired band.
6
3 Select the desired frequency and related data (Tone,
7
CTCSS, etc.) using VFO mode.
8
4 If required, select another band, then select the
9
desired frequency and related data.
10
5 Press [F] , [PM].
11
• The PM channel numbers appear and blink.
12
13
14
15
1
16
6 Press [1] to [4] corresponding to the desired PM
17
channel.
18
• The selected frequency and related data are stored in
the PM channel.
19
20
21
22
36

RECALLING PM CHANNELS

1 Press [PM].
• The PM channel numbers appear.
2 Press [1] to [4] corresponding to the desired PM
channel.
• The contents of the selected channel are recalled.
• The selected channel number appears and slowly
2
• To exit PM Recall mode, press [PM], [PM OFF] .
Note:
blinks.
You cannot recall a PM memory channel while transmitting.