STORING DATA IN PM CHANNELS
1
1 Confirm that the following conditions have been
satisfied:
2
•
Both bands are in the receive mode.
3
•
Scan is not being used on either band.
4
•
Microphone Control is OFF.
5
2 Select the desired band.
6
3 Select the desired frequency and related data
(Tone, CTCSS, DTSS, etc.) using VFO mode.
7
4 If required, select another band, then select the desired
8
frequency and related data.
9
5 Press [F] , [PM].
10
•
The PM channel numbers appear and blink.
11
12
CALL
CALL
13
14
15
6 Press [1] to [4] corresponding to the desired PM
16
channel.
17
•
The selected frequency and related data are stored in the
PM channel.
18
19
20
21
38
PWR
PWR
2
VOL
SQL
1
RECALLING PM CHANNELS
1 Press [PM].
•
The PM channel numbers appear.
CALL
CALL
2 Press [1] to [4] corresponding to the desired PM
channel.
•
The contents of the selected channel are recalled.
•
The selected channel number appears at the left bottom
of the display.
•
To exit PM Recall mode, press [PM], [VFO].
Note: You cannot recall a PM memory channel while transmitting.
PWR
PWR
VOL
SQL