Actuator/Button Sfp Modules - Cisco SN 5428 Hardware Installation

Chapter 2 Installing the SN 5428 Storage Router
Installing SFP Modules

Actuator/Button SFP Modules

The actuator/button SFP module (see Figure 2-10) has a button that you must
push in order to remove the SFP module from a port.
Figure 2-10 Actuator/Button SFP Module
To insert the actuator/button SFP module into a port, line up the SFP module with
the port and slide it in until the actuator/button clicks into place (see Figure 2-11).
Be sure not to press the actuator/button as you insert the SFP module because you
might inadvertently disengage the SFP module from the port.
Figure 2-11 Inserting an Actuator/Button SFP Module
To remove an actuator/button SFP module from a port, perform the following
steps:
Gently press the actuator/button on the front of the SFP module until it clicks and
Step 1
the latch mechanism activates, releasing the SFP module from the port (see
Figure 2-12).
Cisco SN 5428 Storage Router Hardware Installation Guide
2-16
OL-4796-01