Recording; Recording Mode Setting In Digital Audio Source Recording; Recording Audio (Analog Sources); Recording Video - Kenwood KRF-V6300D Instruction Manual

Recording

Recording mode setting in digital
audio source recording
¶ Operation available only on the main unit.
When recording a multi-channel digital audio source, it is
recommended to set up the recording mode properly to convert
the digital input into the 2-channel analog output. Usually use
the "A-REC" (Auto record) mode.
However, some discs often produce sound skipping. The "M-REC"
(Manual record) mode should be used with such a disc.
AUTO/MONO
œ Use [INPUT SELECTOR] to select the source (CD/
DVD, DVD/6CH or VIDEO2) you want to record.
∑ Set the MD or TAPE recorder to record.
é Press and hold [AUTO/MONO] for more than 2
seconds to select a recording mode during digital
input.
Recording mode
Recording mode off
Auto record mode
Manual record mode
When the "A-REC" mode is selected, the digital input
signal is converted to stereo signals even if the digital
signal is changed.
When the digital mode changes during recording
in the "A-REC" mode, the audio input source may be
interrupted momentarily.
For "A-REC" mode:
38
KRF-V6300D
INPUT SELECTOR
Display Operation
The digital input record mode is switched
---
off.
The digital input signals (DTS, Dolby Digital
or PCM) are identified automatically and
"A-REC"
converted into stereo signals that are ready
for recording.
The digital input signal type at the moment
this mode is selected is held throughout
"M-REC" this mode, and the signal is converted into
stereo signals. But once the digital signal is
changed to other signal, no signal is output.
For "M-REC" mode:
® Start playback, then start recording.
If the audio reproduction stops in the middle due to
change in the input signals, etc., press [AUTO/MONO].

Recording audio (analog sources)

œ Use [INPUT SELECTOR] to select the source (other
than "MD/TAPE") you want to record.
∑ Set the MD or TAPE recorder to record.
é Start playback, then start recording.

Recording video

œ Use [INPUT SELECTOR] to select the video source
(other than "VIDEO1") you want to record.
∑ Set the video deck connected to VIDEO 1 to record.
Select the REC MODE to record a digital input source.
See <Recording mode setting in digital audio source
recording>.
é Start playback, then start recording.
Recording may not be normal for some video software.
This is due to the copy guard condition.