For Vigor2950Gi - Draytek Vigor2950 Series User Manual

1 . 2 . 4 F o r V i g
1 . 2 . 4 F o r V i g
LED
ACT (Activity)
DMZ
Monitor
VPN
QoS
WLAN
ISDN
LED on Connector
WAN
LAN/Monitor
LAN
Interface
RST
(Factory Reset)
ISDN
WAN(1/2)
LAN/Monitor
LAN (1- 4)
Vigor2950 Series User's Guide
o r 2 9 5 0 G i
o r 2 9 5 0 G i
10
(left LED)
100
(right LED)
100
(left LED)
1000
(right LED)
Description
Restore the default settings.
Usage: Turn on the router (ACT LED is blinking). Press the hole and keep for
more than 5 seconds. When you see the ACT LED begins to blink rapidly than
usual, release the button. Then the router will restart with the factory default
configuration.
Connect for NT1 (or NT1+) box provided by ISDN service provider.
Connecter for remote networked devices.
Connecter for local networked devices.
Connecter for local networked devices.
Connecter for a power cord with 100-240VAC (inlet).
Power Switch. "1" is ON; "0" is OFF.
Status Explanation
Blinking The router is powered on and running normally.
Off The router is powered off.
On DMZ Host is specified in certain site.
On LAN traffic monitor is active.
On The VPN tunnel is launched.
Off The VPN tunnel is closed.
On The QoS function is active.
On Wireless access point is ready.
Blinking Ethernet packets are transmitting over wireless LAN.
Off The WLAN function is inactive.
On The ISDN service function is active.
Blinking A successful connection on the ISDN BRI B1/B2
channel.
On The port is connected with 10Mbps.
Off The port is disconnected.
Blinking The data is transmitting.
On The port is connected with 100Mbps.
Off The port is disconnected.
Blinking The data is transmitting.
On The port is connected with 100Mbps.
Off The port is disconnected.
Blinking The data is transmitting.
On The port is connected with 1000Mbps.
Off The port is disconnected.
Blinking The data is transmitting.
5