Table of Contents
Advertisement
• When providing Tandem Connection (ISDN to ISDN), do the following programming.
[Series 3600 software required]
L
CM36
Specify the combination of trunk routes allow-
ing the tandem connection.
CM08
Allow tandem connection by station or atten-
dant.
CM35
Provide release of ISDN trunk when receiving
the ISDN DISCONNECT message with
Progress Description=8 from ISDN because
the called party is busy in tandem connection
(ISDN to ISDN).
NOTE:
To release the ISDN trunk when receiv-
ing the ISDN DISCONNECT message,
set the second data 0 to the incoming
trunk route of tandem office.
Provide relay of the ALERT message to the
calling party in tandem connection (ISDN to
ISDN).
NOTE:
This command should be set to both
incoming trunk route and outgoing
trunk route of tandem office.
END
DESCRIPTION
CHAPTER 3 SYSTEM DATA PROGRAMMING
•
Y=0
(1)
XX ZZ
XX: 00-63: Incoming Trunk Route
ZZ : 00-63: Outgoing Trunk Route
(2)
0 : Allowed
1 : Restricted
(1)
028
(2)
0: Available
•
Y=233
(1)
00-63: B channel Trunk Route No.
(2)
0: To provide
•
Y=266
(1)
00-63: B channel Trunk Route No.
(2)
0: To provide
– 100 –
ISDN-PRI PROGRAMMING
DATA
NWA-008852-001 Rev.5.0
98ch3001.fm
NOVEMBER/15/2006
Advertisement
Table of Contents
