Setting Of Pcs-1 And Hub; Audio And Video Input/Output Characteristics; Audio Input/Output Characteristics Of Pcs-1/1P; Video Input/Output Characteristics Of Pcs-1/1P - Sony PCS-1 System Integration Manual

4-2. Setting of PCS-1/1P and HUB
The initial setting of the PCS-1/1P is Auto.
In the Auto setting of the PCS-1/1P, 10/100 can be selected automatically, however, Half/Full cannot be selected
automatically. Therefore, if the HUB is set to Full mode, a connection failure or packet loss occurs. The following table
shows an example of connection between the PCS-1/1P and Catalyst 2950. When the HUB is set to 100FULL or 10FULL,
change the setting of HUB or adjust the PCS-1/1P setting to HUB. Refer to Operating Instructions.
Table of connection between PCS-1/1P and Catalyst 2950
PCS-1/1P setting AUTO
2950 setting
AUTO OK
100FULL Packet loss
100HALF OK
10FULL Packet loss
10HALF OK

4-3. Audio and Video Input/Output Characteristics

4-3-1. Audio input/output characteristics of PCS-1/1P

Name Connector
MIC1/MIC2 (Input) Mini-jack
AUDIO IN (Input) Pin jack
AUDIO OUT (Output) Pin jack
AUDIO OUT (MIXED) Pin jack
(Output)

4-3-2. Video input/output characteristics of PCS-1/1P

Name
VIDEO IN AUX1 (Input)
VIDEO IN AUX2 (Input)
VIDEO OUT AUX (Output)
VIDEO OUT MONITOR MAIN (Output)
VIDEO OUT MONITOR SUB (Output)
RGB OUT (Output)
PCS-1/1P
100FULL 100HALF
Packet loss OK
OK Packet loss
Packet loss OK
Connection failure Connection failure
Connection failure Connection failure
Impedance
4.7 kZ (Plug in power)
47 kZ or higher, Unbalanced
1 kZ or less, Unbalanced
1 kZ or less, Unbalanced
Connector
Mini DIN 4-pin
Pin jack
Pin jack
Mini DIN 4-pin
Mini DIN 4-pin
D-Sub 15-pin
10FULL
Packet loss
Connection failure
Connection failure
OK
Packet loss
Input/output level
The reference value of an input level is _55 dBs.
The reference value of an input level is _9 dBs.
Reference value _12 dBs
Reference value _12 dBs
Specifications
S video input signal
Y signal: 0.7 V p-p/75 Z
C signal: 0.3 V p-p/75 Z
Composite input signal
1 V p-p/75 Z
Composite output signal
1 V p-p/75 Z
S video output signal
Y signal: 0.7 V p-p/75 Z
C signal: 0.3 V p-p/75 Z
S video output signal
Y signal: 0.7 V p-p/75 Z
C signal: 0.3 V p-p/75 Z
RGB video output
(H/V/R/G/B: 0.7 V p-p/75 Z)
10HALF
OK
Connection failure
Connection failure
Packet loss
OK
Remarks
Remarks
PCS-1: NTSC
PCS-1P: PAL
PCS-1: NTSC
PCS-1P: PAL
PCS-1: NTSC
PCS-1P: PAL
PCS-1: NTSC
PCS-1P: PAL
PCS-1: NTSC
PCS-1P: PAL
4-3